Effectiveness of post-fire salvage logging stream buffer management for hillslope erosion in the U.S. Inland Northwest Mountains     

Peter R. Robichaud  Edwin D. Bone  Sarah A. Lewis  Erin S. Brooks  Robert E. Brown 《水文研究》2021,35(1):e13943

Active wildfire seasons in the western U.S. warrant the evaluation of post-fire forest management strategies. Ground-based salvage logging is often used to recover economic loss of burned timber. In unburned forests, ground-based logging often follows best management practices by leaving undisturbed areas near streams called stream buffers. However, the effectiveness of these buffers has not been tested in a post-wildfire setting. This experiment tested buffer width effectiveness with a novel field-simulated rill experiment using sediment-laden runoff (25 g/L) released over 40 min at evenly timed flow rates (50, 100 and 150 L/min) to measure surface runoff travel length and sediment concentration under unburned and high and low soil burn severity conditions at 2-, 10- and 22-month post-fire. High severity areas 2-month post-fire had rill lengths of up to 100 m. Rill length significantly decreased over time as vegetation regrowth provided ground cover. Sediment concentration and sediment dropout rate also varied significantly by soil burn severity. Sediment concentrations were 19 g/L for the highest flow 2-month post-fire and reduced to 6.9–14 g/L 10-month post-fire due to abundant vegetation recovery. The amount of sediment dropping out of the flow consistently increased over the study period with the low burn severity rate of 1.15 g L⁻¹ m⁻¹ approaching the unburned rate of 1.29 g L⁻¹ m⁻¹ by 2-year post-fire. These results suggest that an often-used standard, 15 m buffer, was sufficient to contain surface runoff and reduce sediment concentration on unburned sites, however buffers on high burn severity sites need to be eight times greater (120 m) immediately after wildfire and four times greater (60 m) 1-year post-fire. Low burn severity areas 1-year post-fire may need to be only twice the width of an unburned buffer (30 m), and 2-year post-fire these could return to unburned widths.  相似文献   

西南大西洋阿根廷滑柔鱼资源时空分布研究   总被引：2，自引：0，他引：2  

侯庆联  陈新军  汪金涛 《海洋科学》2019,43(5):103-109

通过了解西南大西洋阿根廷滑柔鱼(Illexargentinus)资源丰度年间变化规律,从而对阿根廷滑柔鱼的资源可持续开发与管理打下基础。作者根据2012～2017年西南大西洋阿根廷滑柔鱼生产统计数据,利用灰色关联评价等数理方法对西南大西洋资源渔场的时空分布特征进行了分析。结果表明,2012～2017年间西南大西洋阿根廷滑柔鱼渔场重心主要在经度上分布于58°W～63°W海域,纬度主要集中在41°～44°S、47°～48°S两个区域,高平均网次产量(10 t/网)的海域主要在57°W～67°W、41°S～42°S和57°W～67°W、44°S～50°S海域。灰色关联度表明:6年间,以2015年滑柔鱼资源状况最好,其次是2014年,2012年最差,2013年、2016年和2017年处于中间水平。利用灰色关联分析的阿根廷滑柔鱼资源丰度变化趋势可用于其资源的可持续开发与管理。  相似文献   

Validation of the SCEC Broadband Platform simulations for tall building risk assessments considering spectral shape and duration of the ground motion     

Nenad Bijelić  Ting Lin  Greg G. Deierlein 《地震工程与结构动力学》2018,47(11):2233-2251

Earthquake simulation technologies are advancing to the stage of enabling realistic simulations of past earthquakes as well as characterizations of more extreme events, thus holding promise of yielding novel insights and data for earthquake engineering. With the goal of developing confidence in the engineering applications of simulated ground motions, this paper focuses on validation of simulations for response history analysis through comparative assessments of building performance obtained using sets of recorded and simulated motions. Simulated ground motions of past earthquakes, obtained through a larger validation study of the Southern California Earthquake Center Broadband Platform, are used for the case study. Two tall buildings, a 20‐story concrete frame and a 42‐story concrete core wall building, are analyzed under comparable sets of simulated and recorded motions at increasing levels of ground motion intensity, up to structural collapse, to check for statistically significant differences between the responses to simulated and recorded motions. Spectral shape and significant duration are explicitly considered when selecting ground motions. Considered demands include story drift ratios, floor accelerations, and collapse response. These comparisons not only yield similar results in most cases but also reveal instances where certain simulated ground motions can result in biased responses. The source of bias is traced to differences in correlations of spectral values in some of the stochastic ground motion simulations. When the differences in correlations are removed, simulated and recorded motions yield comparable results. This study highlights the utility of physics‐based simulations, and particularly the Southern California Earthquake Center Broadband Platform as a useful tool for engineering applications.  相似文献   

高精度直升机机载LiDAR在高速公路改扩建勘测中的应用可行性研究          下载免费PDF全文

郑伟安 《山东国土资源》2018,34(8)

机载LiDAR在公路勘测方面的用途日益广泛。该文对直升机机载LiDAR在高速公路改扩建中的应用技术路线可行性进行了研究论证,从地面控制测量、点云数据获取、点云数据处理、成果应用等多个方面进行了阐述,通过分析LiDAR点云数据在5种不同地面控制点布设方案校正下的点云数据精度,论证了利用地面控制点对直升机机载LiDAR点云数据进行平面和高程校正的可行性。  相似文献   

Analytical study of ground motion caused by seismic wave propagation across faulted rock masses          下载免费PDF全文

J.C. Li  N.N. Li  S.B. Chai  H.B. Li 《国际地质力学数值与分析法杂志》2018,42(1):95-109

Studying seismic wave propagation across rock masses and the induced ground motion is an important topic, which receives considerable attention in design and construction of underground cavern/tunnel constructions and mining activities. The current study investigates wave propagation across a rock mass with one fault and the induced ground motion using a recursive approach. The rocks beside the fault are assumed as viscoelastic media with seismic quality factors, Q_p and Q_s. Two kinds of interactions between stress waves and a discontinuity and between stress waves and a free surface are analyzed, respectively. As the result of the wave superposition, the mathematical expressions for induced ground vibration are deduced. The proposed approach is then compared with the existing analysis for special cases. Finally, parametric studies are carried out, which includes the influences of fault stiffness, incident angle, and frequency of incident waves on the peak particle velocities of the ground motions.  相似文献   

Review on the study of topographic effect on seismic ground motion          下载免费PDF全文

Hong Zhou 《地震科学（英文版）》2018,31(2):110-116

Topographic effect study is a very important research topic in seismology, seismic engineering,earthquake engineering, engineering earthquake construction and engineering seismology. This paper focuses on its present development status. Post-earthquake investigation has found that the existence of topography caused more serious earthquake damage. The actual seismographs also recorded the topographic amplification effect of 6 to 7 times and even more than 10 times. Numerical simulation is an important technique to study topographic effect, which complements the lack of observed records. However researches on 3-D topographic effect are not enough and need to be studied deeper. To find the main influence factors and the quantitative relationship between topography and ground motion are required very urgently. Obviously the achievements not only can be applied in the earthquake resistant design, but also can provide the quantitative pre-earthquake disaster prediction and quantitative post-earthquake disaster evaluation.  相似文献   

强夯振动加速度的量测及现场试验研究   总被引：1，自引：0，他引：1       下载免费PDF全文

李盼盼  王家鼎  谷天峰  刘亚明 《地震工程学报》2018,40(1):166-170

结合延安新区强夯加固地基工程,进行强夯振动加速度测试现场试验。选取填方区场地,结合地形设计监测方案,以测试强夯波沿水平方向和斜坡的传播规律。在选定试验段的某级填方场地上布置多组加速度传感器,运用多个8通道24位高速采集卡记录强夯振动加速度在平面和斜坡的传播和衰减过程,探讨强夯振动波沿水平面和斜坡的传播规律以及能级对振动加速度的影响。结果表明:径向和竖向加速度值均随与夯点距离的增大而减小;在与夯击点距离相同处,强夯振动波沿水平方向传播的径向和竖向加速度值要大于沿斜坡方向;随着能级的增大,强夯产生的夯击波增强,在与夯击点相同距离处产生的径向和竖向加速度均明显增大。  相似文献   

RESEARCH ON PASSIVE SERVO SEISMIC ROTATIONAL ACCELERATION SENSOR WITH LARGE DAMPING     

QU Ming-zhe  GAO Feng  YANG Xue-shan  YANG Dong-xia 《地震地质》2018,40(5):1170-1178

Many strong motion records show that under the strong seismic vibration of, the torsional disfigurement of building structures is a common and serious damage. At present, there are no special sensors for measuring seismic rotation in the world. Most of the experts obtain rotational components through observing deformation, theoretical analysis and calculation. The theory of elastic wave and source dynamics also prove the conclusion that the surface of the earth will rotate when an earthquake occurs. Based on a large number of investigations and experiments, a rotational acceleration sensor was developed for the observation of the rotational component of strong ground motions. This acceleration sensor is a double-pendulum passive servo large-damped seismic rotational acceleration sensor with the moving coil transducer. When an earthquake occurs, the seismic rotational acceleration acts on the bottom plate at the same time. The magnetic circuit system and the middle shaft fixedly connected to the bottom plate follow the bottom plate synchronous vibration, and the moving part composed of the mass ring, the swing frame and the moving ring produces relative corners to the central axis. The two working coils mounted on the two pendulums produce the same relative motion with respect to the magnetic gaps of the two magnetic circuits. Both working coils at this time generate an induced electromotive force by cutting magnetic lines of force in the respective magnetic gaps. The generated electromotive forces are respectively input to respective passive servo large damper dynamic ring transducer circuits and angular acceleration adjusting circuits, and the signals are simultaneously input to the synthesizing circuit after conditioning. Finally, the composite circuit outputs a voltage signal proportional to the seismic rotational acceleration to form a seismic rotational acceleration sensor. The paper presents the basic principles of the rotational acceleration sensor, including its mechanical structure diagram, circuit schematic diagram and mathematical models. The differential equation of motion and its circuit equation are derived to obtain the expressions of the main technical specifications, such as the damping ratio and sensitivity. The calculation shows that when the damping ratio is much larger than 1, the output voltage of the passive servo large damping dynamic coil transducer circuit is proportional to the ground rotation acceleration, and the frequency characteristic of bandpass is wider when the damping ratio is larger. Based on the calibration test, the dynamic range is greater than or equal to 100dB and the linearity error is less than 0.05%. The amplitude-frequency characteristics, the phase-frequency characteristics and their corresponding curves of the passive servo rotational acceleration sensor are acquired through the calculations. Based on the accurate measurement of the micro-vibration of the precision rotating vibration equipment, the desired result is obtained. The measured data are presented in the paper, which verify the correctness of the calculation result. The passive servo large damping rotational acceleration sensor has simple circuit design, convenient operation and high resolution, and can be widely applied to seismic acceleration measurement of earthquake or structure.  相似文献   

Character and origin of De Geer moraines in the Seacoast region of New Hampshire,USA          下载免费PDF全文

Samantha N. Sinclair  Joseph M. Licciardi  Seth W. Campbell  Brian M. Madore 《第四纪科学杂志》2018,33(2):225-237

  相似文献   

地面稠密观测资料在强对流天气监测预警中的研究进展     

李佩芝  周长春  华维 《云南地理环境研究》2020,(1):53-58

综述国内外数篇论文,从强对流天气监测、预报预警、模式同化3个方面总结分析了近年来地面稠密观测资料的应用与优劣之处。综述表明:地面加密自动站、风廓线雷达、地基GPS、雨滴谱仪等多种观测仪器组成的地面稠密观测网具有时间尺度密集、覆盖面积广泛、能捕捉较多细微变化的优势,通过该观测网所得数据总结出的一系列指示性指标在强对流监测预警中具有重要的指示意义。但因中国地形天气情况复杂多变、数据缺失、仪器造价昂贵等问题,导致该观测网所得指示性指标不能适用于中国全境,应根据该观测网数据分析总结适应本地的预报指标。  相似文献